Oakworks EC Series Procedure Chair - Manual (Page 11)

8
DIRECTIONS FOR USE
CAUTION
RETRACTABLE FOOT RESTS (STIRRUP) USE
Pinch Point - Keep fingers away from pinch point.
Double articulating action provides nearly limitless positioning options with the QuickLock ™ Face
Rest. The adjuschair pad takes pressure off sensitive facial areas while providing superb support. The
QuickLock
™
Face Rest can be used in both prone and supine positioning and folds out of the way
when not in use. Adjustments are made easily by loosening the cam locks, adjusting for height and
angle and then locking the cam locks into the desired position.
Important Safety Note:
Maximum Distance from edge
of Chair = 3” (7.6 cm.)
Insert dowels into
Accessory attachment
outlets.
Loosen Cam Locks &
adjust face rest into place.
The Face Rest can be used for either
prone or supine positioning.
Tighten the Cam Locks.
QUICKLOCK FACE REST
* U.S. Patent #5,177,823
CAUTION Do not put excessive weight or pressure on the Quicklock Face Rest. Do not
extend the dowels of the Quicklock Face Rest more than 3” (7.6 cm.) from
the Backrest
Accessory attachment outlets
1. Fully rase the leg rest.
2. Grasp Stirrup handle &
pull out firmly while lifting
slightly.
3. Rotate outward.
4. Fold out to fully open position.
5. Place feet in stirrups.
6. Lower leg rest.
7. Rotate stirrup to the
desired angle.
8. To reduce stirrup length, lift
the handle slightly and push
into desired position. Stirrup
will automatically lock into
nearest detent position.
To store stirrups, fold leg rest down, lift slightly,
rotate towards the middle of the chair and push into
the storage position.