Oakworks Clodagh Virgo - Manual (Page 10)

8
Plug the cord into a functioning outlet that is rated for the table.
(Electric models only)
Arrange the power cord and foot switch (electric model only) so that they will
not create a tripping hazard. Place the controls in a safe location where they
are convenient and accessible. Keep the controls out of the way of all table
mechanisms.
INSTALLATION
INSTALLATION
INSTALLATION
If Table Will Not Sit Flat on the Floor:
The Virgo ™ is equipped with Leveler Feet that adjust to level the table
on uneven floors. To adjust the Leveler Feet to suit common floor
differences you will need to use a 1 /
2
” open-end wrench or an adjust-
able wrench. Adjust each leg individually in turn by adjusting the height
of each leveler foot until the unit rests level and steady. This adjust-
ment will not effect the function of the table.
LEVELING INSTRUCTIONS
CAUTION
The table weighs as much
as 200 lbs.
DO NOT lift or
move the unit without using
proper safely procedures
or equipment.
DO NOT turn
the table on its side for any
reason. To do so could
cause damage to the base
and
will void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not
designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT 8
1/2” Open-end Wrench