Oakworks Cabana Lounger - Manual (Page 9)

DIRECTIONS FOR USE
6
OPTIONAL BENCH BACKREST
OPERATION (IF APPLICABLE)
TO RAISE THE BENCH BACKREST
NOTE: The table legs must be extended at least 10 inches to allow the bench
backrest to swing into position.
Raise the table backrest so that you can see the fabric loop holding the bench
backrest on a hook. Using one hand, lift the bench backrest up to provide
slack on the fabric loop. Remove the fabric loop from the hook and swing the
bench backrest into place. Secure with the knob.
TO LOWER THE BENCH BACKREST
NOTE: The table legs must be extended at least 10 inches to allow the bench
backrest to swing into position.
To take the bench backrest down, unfasten the knob. Carefully swing the
bench backrest down and allow to rest. Raise the table backrest. Reach
through the table and grasp the bench back rest. Swing forward and place
the fabric loop over the hook to secure the bench backrest under the table.
The standard backrest converts to a seat and must be all the way down to the
lowest position. The long “bench” backrest is available as an option. This is
stored under the table and swings into position when desired.
DIRECTIONS FOR USE