Oakworks 300 Series Procedure Chair Rev.D - Manual (Page 10)

DIRECTIONS FOR USE
The chair can be easily rotated without a patient in it. This is the preferred method. To rotate the chair with an
average size patient, lower the backrest to about 45° to allow easier rotation.
To rotate the chair, locate the black push buttons at the top of the back rest section. Press in and hold either
one of the buttons to disengage the base locking mechanism. While holding in the push button, rotate the chair
to the desired position up to 240°.
7
CAUTION
SWIVEL BASE USE
When rotating the chair, make sure there is nothing around the chair that can impede
the rotational motion (like stools, cabinets, etc)
Rotate up
to 240
º
1. Fully lower the powered
foot rest to allow access to
the stirrup.
3. Fold out to fully open posi-
tion.
2. Grasp Stirrup handle &
pull out firmly while lifting
slightly. Pull fully out.
4. To rotate stirrup to the
desired angle, lift slightly
and move to the desired
position. There are (3)
detent positions. Stop lift-
ing and move slightly left
or right for the nearest
detent position.
5. To reduce stirrup length,
lift the handle slightly and
push into desired position.
Stirrup will automatically
lock into nearest detent
position.
To store stirrups, lift slightly, rotate towards the middle of the chair and fold
the foot rest down. Then lift slightly and push into the storage position.
RETRACTABLE FOOT RESTS (STIRRUP) USE
CAUTION
Pinch Point - Keep fingers away from pinch point.