NORAC UC5-BC-AGCO-RMC - Manual (Page 7)

7 |
Boom status is shown in the lower left corner of the RMC. When the system is in Automatic Mode, the
boom will be green with “A”’s displayed. When the system is in Manual Mode, the boom will be grey
with “M”’s displayed.
When the UC5™ Height Control system is in Automatic Mode, arrows will appear on the screen above
or below the boom sections. These arrows indicate the UC5 system is making a correction to part of the
boom in the displayed direction. Often the correction will be very small and there may not be a
noticeable change in boom position.
The height displayed on the boom is measured from the spray nozzles to the soil (Soil Mode) or to the
crop canopy (Crop Mode). The target height will be displayed in the upper right corner of the screen. If
there are five height sensors on the sprayer, the height displayed is the outer sensor for each boom
section.
Settings Button
Manual Button UC5 Button
Boom Status
Auto Button