Calibrating boom geometry – NORAC UC5-BC-AGCO-RMC User Manual

Page 46

Text mode
Original mode

46 |

5.6.4. Calibrating Boom Geometry
1. Ensure the sprayer is over bare level soil or gravel.
2. Ensure the boom is level and approximately 1 to1.5m (3 – 5 feet) above the ground.
3. Navigate to the boom geometry test (Run Screen-> Settings-> Next-> Next-> Setup-> Boom

Geometry Test).

4. The booms will be moved into position and, the display will prompt you to exit the cab and manually

push either boom tip down. Stay at least 3 feet from the sensor.

5. Push either boom tip down 1 – 3 feet (30 – 90 cm) for a moment and then let go. Do not push the

boom to the ground.