NORAC UC5-BC-AGCO-RMC - Manual (Page 48)

48 |
6. UC5 System Maintenance
6.1. Daily Maintenance:
 Grease the friction pads on the sprayer boom.
 Ensure there is a clean and dry foam inserted into each sensor.
6.2. Cleaning Ultrasonic Height Sensors:
 Remove the foam disc from the sensor and wash it with clean water. Squeeze out water and
allow the foam disc to dry.
 If the transducer inside the sensor is also dirty, wash it using clean water. Do not submerge or
pressure-wash the sensor.
 Chemicals or compressed air should never be used.
 The sensor can be used if it is wet, however a valid height reading may not be obtained until it is
completely dry.