NORAC UC5-BC-AGCO-RMC - Manual (Page 34)

34 |
5.3.4. Short Circuit Test
1. Disconnect all the height sensors, modules, roll sensors and power from the NORAC CANbus.
Ensure all cables and terminators are connected together.
2. Using an ohm meter, test the resistance of all the pin combinations on the 6-pin connector (C01).
3. If an incorrect value is measured, continue by testing at the next connection until the problem cable is
isolated.
Pin # Pin # Value
1 2 Open Circuit
1 3 Open Circuit
1 4 Open Circuit
1 5 Open Circuit
1 6 Open Circuit
2 3 Open Circuit
2 4 Open Circuit
2 5 Open Circuit
2 6 Open Circuit
3 4 75Ω ± 10Ω
3 5 Open Circuit
3 6 Open Circuit
4 5 Open Circuit
4 6 Open Circuit
5 6 Open Circuit