NORAC UC4+BC+HD4 Part 1 - Manual (Page 37)

33
4.11 NORAC V
ALVE AND
S
ENSOR
C
ONNECTIONS
1. Route the 6-pin shroud (S6) and 4-pin AMP
plug (P4) on C11 to the rear of the sprayer
near the sprayer valve block.
2. Connect the 6-pin tower on the valve cable
(C03) to the mating 6-pin shroud (S6) on
C11 (Figure 29).
3. Install the 2-pin connectors from C03 onto
each NORAC valve as shown in Figure 38.
4. The connectors on the valve cable (C03)
are marked RIGHT UP, LEFT UP,
RIGHT DOWN and LEFT DOWN.
Cables labeled with UP go on the same side
as the hydraulic hoses.
Figure 38: Valve Cable Connections
5. Connect the sensors (E02) to the 4-pin
AMP connectors on cable C02.
6. Connect the roll sensors (E03 & E04) to
the 4-pin AMP connectors on cable C02A.
For details on mounting the UC4
Control Panel (Item E01) and
necessary electrical connections
inside the cab, refer to the UC4-BC-
HD4E End-User document.