NORAC UC4+BC+HD4 Part 1 - Manual (Page 35)

31
Figure 34: DAH09 PCB for AutoHeight
11. Configure the system for Autoslant by
setting the DIP switches on DAH09 board:
a) Set DIP switches 2,3,4,6 and 8 to ON.
Set DIP switch 5 and 7 to OFF (Figure
35).
Figure 35: Suggested Default Setting for
DIP Switches 2-8 for AUTOSLANT
b) If the sprayer uses a DAH valve block set
DIP switch 1 to OFF. If the sprayer uses
a DH valve block set DIP switch 1 to
ON. See Figure 36.
12.
Close the electronics enclosure. Gather up
excess cable (C11 & C02) and neatly cable-
tie to the machine.
Figure 36: HARDI DAH (DIP 1 OFF) vs. DH Block (DIP 1 ON)
DB15
DIP switches
12 VDC and GND