NORAC UC4+BC+HD4 Part 1 - Manual (Page 22)

18
4.5.1 FORCE / TWIN FORCE (HPZ/ HAZ)
Mount the Boom Roll Sensor (E04) to the
boom center section, as illustrated below.
Ensure the circular connector is pointing
towards the right hand wing (when looking from
the rear of the sprayer). Fasten with cable ties.  Item E03 (has temperature probe) is
attached to the non-rotating part of the
boom.
 Item E04 is attached to the rotating part
of the boom.
Figure 19: Boom Roll Sensor Mounting (viewed from rear of sprayer)
E04
E03