New England Arbors VA42037 - Manual (Page 10)

110
110
Beam In
sert
Vinyl Beam Assembly
1
www.edenarbors.com
Insert two short steel stiffener into one long steel stiffener to
create full length piece. Repeat so you have two full length beams.
Insert the end of the vinyl beam marked ‘A’ into the joiner. Install
the joiners so that the side with the four holes are facing up.
Push firmly until the extrusion bottoms out inside the joiner.
Please Note:
Ensure to orientate the main beams correctly so the pre-drilled
holes for future installation of rafter brackets is correct.
Insert one assembled steel stiffener (with steel block facing up),
into the lower pocket of the vinyl beam past the joiner. Push
until steel block hits the internal ribbing.
Slide the other end of vinyl beam marked ‘A’ over the steel insert
and into the joiner.
Screw the joiner to vinyl beams and steel insert using 1 1/2”
screws. The bottom and top holes will need to be pre-drilled
(use drill bit provided).
Install the rafter brackets to the main beams using 5/8”
screws. Follow the pre-drilled holes to identify locations.
1
2
3
S T E P F O U R
4
5
2
10 10 x 10 Flat Top Pergola
3
5
6
6
Four holes facing up
4
Pre-drill holes on bottom and top to
accomodate for internal steel stiffener.
At this stage, the columns should be properly
installed as per the following illustration,
with the columns 110” apart.
Also, notice that the holes at the top of each
post should be facing the same direction.
Beam In
sert
Beam In
sert
Beam In
sert
Beam In
sert
Beam In
sert
Bea
Steel block should face up
A
A
A
Note: If you have base molding on your
posts, measure above moldings as the
measurement is to be from post to post.