New England Arbors VA84250 - Manual (Page 3)

S T E P T W O
3 The Nantucket Legacy Arbor
S T E P T W O
Insert the Lattice into the horizontal rails as illustrated.
Lay post on flat surface with holes facing up.
Insert assembled panel into post. Push until tabs lock
into place.
Layout opposite post and insert the side panel assembly
as shown.
Assemble the Side Panels
1
2
4
1
3
www.newenglandarbors.com
NOTE: if you intend to hand a gate from the arbor, before you install the arch,
insert a 1 x 4 wood board approximately 5 ft. (152.4 cm) up the inside of vinyl cavity.
(1 x 4 wood board purchased separately)
2
Shown with gate (purchased separately)
Ground
A top view showing the
cavity of the post with a
1x4 wood board.
1x4 Wood board
Vinyl Post
Gate Hinge
Fasteners
Side Panel Horizontal Rail
4
3
4
Push until locking tabs
on rails “snap” into place.