New England Arbors VA84070 - Manual (Page 4)

S T E P T H R E E
4
Fasten the seven filters with the screws provided, aligning
them to the pre-drilled holes on top of the beams as shown.
Apply a small amount of glue to the pergola ends for both
the filters and beams as shown. ensure proper orientation of
the pergola ends. Allow a few minutes for vinyl glue to cure.
1
The Carolina Composite Arbor
Connect Filters and Pergola Ends
2
1
3
5
For added stability, fasten two-3” screws on top of each end
filters into the braces as shown.
To secure post trim into place, apply a generous amount of
vinyl weld onto the perimeter of the posts as shown.
Proceed to slide the post trim up the post to the desired
location and allow a few minutes for the vinyl glue to set
and cure.
3
4
2
5
4
www.newenglandarbors.com