New England Arbors VA84070 - Manual (Page 2)

S T E P O N E
2
Layout the horizontal bottom rail and insert the two long vertical
spindles followed by seven of the middle rails. The spacing should be
roughly 5 1/2” apart. Subsequently, place the horizontal top rail over the
two long vertical spindles as shown aside.
Set out one post and slide side panel into place as shown.
Note the L and R on the posts.
Lay out the second post with holes facing upwards and insert
the completed panel and connected post. Please note the locations
of the screw holes to ensure proper installation.
With 3” screws provided, secure bottom and top rails into the post
through the pre-drilled holes as shown aside.
Slide the post trim cap over each of the posts. Allow the post trims to
slide down the post as they will be loose at this point.
Glue and attach the post cap insert over the posts as shown.
The Carolina Composite Arbor
Assemble the Side Panels
1
3
2
2
3
4
4
1
5
6
6
5
www.newenglandarbors.com