Microtel Series 1000EX - Manual (Page 51)

MICROTEL Series 1000EX Dialer
45
Printer Operations
If local printer logging is enabled, all dialer events--alarms, answered and originating
telephone calls, diagnostic messages--are time/date stamped and logged to an external
printer connected to the dialer's serial printer port. Also, "snapshot" status reports or
printouts of all programmed configuration data can be initiated by entering one of the
following touch-tone commands from a local or remote telephone. The commands to use
the printer are given below.
z Enable/Disable Printer The enable command will enable continuous printer logging
of all dialer status changes (input and output state changes, call-outs, alarm
acknowledgments, power on/off cycles, etc.). The disable command disable
continuous printer logging.
0**52* Enable printing
0**53* Disable printing
Example- Command:
0**52*
Response: Printing Enabled.
Example- Command: 0**53*
Response: Printing disabled.
NOTE: You must disable printing before you can enable the Testset feature described in
the Advanced Operations Chapter.
z Print Status Report This command will cause a snapshot printed report of current
status information.
0**50*
Print status report
Examples-
Command: 0**50*
Response with printer enabled: Printing status report.
Response with printer disabled: Printing disabled.
z Print Configuration Report This command will cause a printed report of all non-
voice configuration information. The printer must be enabled to print a report.
0**51* Print configuration report
Examples-
Command: 0**51*
Response with printer enabled: Printing system setup report.
Response with printer disabled:: Printing disabled.