Microtel Series 1000EX - Manual (Page 36)

MICROTEL Series 1000EX Dialer
30
Automatic Call Outs
Use the following two commands to program your dialer to deliver a spoken or FAX
status report of the monitored site at specific times on a weekly or daily basis.
z Call At Time When a timer in the HHMM format matches the current time, a status
update call will be placed to the system calling list (described below). The time that
can be set as either once a week or once a day at a specified time. Once the command
is entered, the response will report the next Call At Time.
0*62*
Report Next Call At time
0**62wHHMM* Program Call At time
Use the table below to set the Call at Time dates.
w 0 1 2 3 4 5 6 7 9
Value None Sun Mon Tues Wed Thurs Fri Sat Daily
Examples- Command:
0**6210832*
Response: The Call At time is Sunday zero eight three two.
If the current time is 11am on Wednesday,
Command: 0**6291210*
Response: The Call At time is Wednesday one two one zero.
-or-
Command: 0**6291010*
Response: The Call At time is Thursday one zero one zero.
z Call At List A list of phone numbers to call when the Call At Time occurs.
0*63*
Report Call At telephone list
0**63tt* Program Call At telephone list
(t is a list of 0 to 9 telephone index numbers (01,02,…32) followed by a *).
Example- Command:
0**63020822*
Response: The system telephone list is two and eight and two two.
When the system Call At Time is reached, phone calls will be placed to phone
numbers 2 then 8 then 22 repeatedly until the alarm is acknowledged.
NOTE: When calling a fax machine, to prevent multiple faxes, embed the auto
acknowledge escape code (*90) in the last telephone number in the call at list.
Telephone Numbers