Microtel Series 1000EX - Manual (Page 27)

MICROTEL Series 1000EX Dialer
21
z Repeat procedure for the next alarm and corresponding I/O channel. Channel 9,
the internal power fail alarm, can also be configured to call on alarm.
11. Record System and Alarm Voice Messages (Optional)
System ID Voice Message
z Press 0**01* to record up to a six second system voice message. The dialer will
respond “Ready”.
z Speak your message clearly into the handset. You may trim the message by
pressing any touch tone button.
z Verify your message by pressing 0*01* to listen.
Individual Alarm Messages
z Press **cc1* to record an alarm message for a specific I/O channel. (cc = 01 to
41 for the I/O channel of interest). The dialer will respond “Ready”.
z Speak your message clearly into the handset. You may trim the message by
pressing any touch tone button.
z Verify your message by pressing *cc1* to listen.
z Repeat procedure for the next I/O channel and message.
NOTE: The Dialer will use its internal, digitized voice and vocabulary for alarm
reporting if you do not record these messages.
12. Test Call Out
Force a test call to one of the telephone numbers you entered after configuring your
Dialer. Enter 0**57nn*, where n = 01-32, is the directory index of the telephone
number.
After the dialer responds, the dialer will wait for you to hang up the phone before
calling the number you specified.
13. Verify Configuration Data is Saved in the Dialer.
Turn OFF the Dialer’s power switch, wait a few seconds, then turn it ON again. The
red Power/Fault light should pulse with a 95% duty cycle indicating the new
configuration data has been saved in memory.
Many more features are available with the Series 1000EX Dialer. Read the Operations
and Advanced Topics chapters for more information on configuring the dialer for your
specific application.