MF Digital DIRECTOR PRO Series - Manual (Page 13)

MF Digital Director/Director Pro Series Publishing System User Manual Revised July 2010
Page 13
Starting the DIRECTOR/DIRECTOR PRO For the First Time
Before Disc creation or duplication can begin it is necessary to review a few
details.
Power Connection and Settings
• Make sure the DIRECTOR/DIRECTOR PRO power switch is set to the
off position or “0”.
• The unit has an auto switching power supply that supports 100 – 240V
AC.
• Plug one end of the supplied power cord into the receptacle at the rear of
the unit and the other end into the wall or UPS power outlet.
CAUTION
Always use properly grounded receptacles, or severe damage to
your system may result. The use of a surge protector or
Uninterruptible Power Supply (UPS) is highly recommended.
Starting Up
• Flip the DIRECTOR/DIRECTOR PRO power switch to the “on”
position.
• Switch on the power to the printer.
• Wait a minute or two while the system starts up. A series of diagnostic
information will be displayed and once complete the unit will display
the Windows desktop.
The DIRECTOR/DIRECTOR PRO uses Microsoft’s Windows For the
operating system. To get the most out of the DIRECTOR/DIRECTOR
PRO it is recommended that users supplement this manual with a
Windows guide.
Note: