Maxim Integrated 73M1966B - Manual (Page 6)

73M1866B/73M1966B GUI User Guide UG_1x66B_002
6 Rev. 1.1
2 Getting Started
This section describes how to install, start and use the GUI software.
2.1 GUI Installation
Load the GUI software from the CD onto the PC that will be used to control the configuration of the
73M1x66B Demo Board.
If the GUI software does not run automatically when the
CD is installed, select Start
 Run and browse the CD
drive for Teridian_73M1966_1_3_SETUP.EXE.
Select OK. The following window appears.
Select Run.
Select Yes to continue.
The following window appears.
This window lists the revisions of the GUI software
and the improvements made in each revision.
Select Next. The following window appears.