Mpg106 instructions #3, Malone – Malone MPG106MD User Manual

Page 4

MALONE

Installation & Loading Instructions - MPG106M (MD) AutoLoader

. Thread the free ends of each strap

down and under the cross bar, and,

back up through the boarding ramp

slot.

See image 13. Note: On some

factory models, the free strap ends

must be threaded back under the

carriers in order reach the cross bars.

. Pull the free end of each strap loop down

until the buckles are positioned half way up

the side of the kayak. Thread each free end

down and through the inside bottom slot in

each carrier. See image 12.

. Thread the free strap ends up and through

the buckles. Pull down to tighten. Dress

any extra strap down and around the cross

bars.

. For MD series: Install the bow & stern safety

lines per the attached instructions.

. Note: Safety tie-downs are required for all

transport.

Always check mounting hardware, load straps and safety tie-down lines for proper

and secure attachment before transport. Use of this product for any other

application other than kayak transport voids warranty.

MALONE AUTO RACKS, 81 County Road, Westbrook, Maine 04092

Phone: 207-774-9100 Fax: 207-615-0551

Website: www.maloneautoracks.com Email: [email protected]