Malone MPG106MD - Manual (Page 2)

MALONE
R
Installation & Loading Instructions - MPG106M (MD) AutoLoader
5
. Confirm the carriers are in alignment.
Firmly tighten the T-knobs until both
carriers are securely fixed to the cross
bars. See image 5.
. Insert a second Mounting Bolt into the top
side unused hex hole and down through the
Jawz mounting adapter. Apply a second
T-knob and slightly tighten until the carrier
is secure. Repeat steps 1-4 for the 2nd
carrier and rear cross bar. See image 4.
. Insert the four Rubber Plugs into the four
top side hex holes in the two carriers. See
image 6.
Step 2: Loading the Kayak
. Route the free end of a 12’ Load Strap
through the rear of the top strap slot in
the top of the carrier. Pull the free end
down until there is an even loop. Repeat
for the second carrier. See image 7.
TM
4
6
7