Malone MPG110MD - Manual (Page 3)

10
MALONE
R
Installation & Loading Instructions
Step 1: Installing the Carriers onto the Cross Rails
. Insert a mounting bolt into the left side hex hole and down through the Jawz
adapter and evenly tighten T-knobs until carrier is firmly seated on the rear
cross bar. See image 10.
. Install the second carrier using same procedure (steps 7-10). See image 11.
Note: Confirm that both carriers are installed so that the rounded side of each
base is facing outward (towards the closest edge of the vehicle’s roof).
Step 2: Loading & Securing the Kayak
. Both front & rear carriers should now be installed. See image 12.
. Position the kayak at the rear of the vehicle. Lift the front of the kayak up and
place into the rear carriers. See image 13.
Note: To avoid damaging the vehicle and kayak, place some type of protective
material on the rear of the vehicle.
. Push the kayak forward until it is centered on the front and rear carriers. See
image 14.
Adjust all four carriers to achieve maximum hull contact. Securely tighten
all of the T-knobs after final kayak to carrier positioning.
Roof
Edge
11
Mounting
Bolt
13
14
12
For MPG109MD-R: Installation complete. Additional carriers (MPG109MD-F) are required for transport.
For MPG110MD: Continue instructions on Loading & Securing the Kayak (steps 12-20).
Front
Rear
TM