Longshine LCS-8156C1 - Manual (Page 91)

AT Commands for CX930xx Modem Reference Manual
102752B Conexant 3-67
\K - Break Control
Controls the response of the modem to a break received from the DTE or the remote
modem or the \B command. The parameter value, if valid, is written to S40 bits 3, 4, and
5.
Syntax
\K
Defined Values
Decimal number corresponding to the selected option.
The response is different in three separate states.
The first state is where the modem receives a break from the
DTE when the modem is operating in data transfer mode:
0 Enter on-line command mode, no break sent to
the remote modem.
1 Clear data buffers and send break to remote
modem.
2 Same as 0.
3 Send break to remote modem immediately.
4 Same as 0.
5 Send break to remote modem in sequence with
transmitted data. (Default.)
The second case is where the modem is in the on-line
command state (waiting for AT commands) during a data
connection, and the \B is received in order to send a break to
the remote modem:
0 Clear data buffers and send break to remote
modem.
1 Clear data buffers and send break to remote
modem. (Same as 0.)
2 Send break to remote modem immediately.
3 Send break to remote modem immediately.
(Same as 2.)
4 Send break to remote modem in sequence with
data.
5 Send break to remote modem in sequence with
data. (Same as 4.) (Default.)