Longshine LCS-8156C1 - Manual (Page 128)

AT Commands for CX930xx Modem Reference Manual
3-104 Conexant 102752B
S23 - General Bit Mapped Options Status
S23 indicates the status of command options.
Default: 0
Bits 0-6 Not used
Bits 6-7 Guard tone (&Gn)
0 = None (&G0) (Default.)
1 = None (&G1)
2 = 1800 Hz (&G2)
S24 - Sleep Inactivity Timer
S24 sets the length of time, in seconds, that the modem will operate in normal mode with
no detected telephone line or DTE line activity before entering low-power sleep mode.
The timer is reset upon any DTE line or telephone line activity. If the S24 value is zero,
neither DTE line nor telephone inactivity will cause the modem to enter the sleep mode.
Range: 0-255 seconds
Default: 0
S25 - Delay To DTR Off
S25 sets the length of time that the modem will ignore DTR for taking the action
specified by &Dn. Its units are seconds for synchronous modes and one hundredths of a
second for other modes.
Range: 0-255 (1 second for synchronous modes 1; 0.01 second otherwise)
Default: 5
S26 - RTS to CTS Delay
S26 sets the time delay, in hundredths of a second, before the modem turns CTS ON
after detecting an OFF-to-ON transition on RTS when &R0 is commanded. Pertains to
synchronous operation only.
Range: 0-255 hundredths of a second
Default: 1