Longshine LCS-8156C1 - Manual (Page 90)

AT Commands for CX930xx Modem Reference Manual
3-66 Conexant 102752B
\B - Transmit Break to Remote
In non-error correction mode, the modem will transmit a break signal to the remote
modem with a length in multiples of 100 ms according to parameter specified. If a
number in excess of 9 is entered, 9 is used. The command works in conjunction with the
\K command.
In error correction mode, the modem will signal a break through the active error
correction protocol, giving no indication of the length.
Syntax
\B
Defined Values
Decimal number corresponding to the selected option.
1-9 Break length in 100 ms units. (Default = 3.)
(Non-error corrected mode only.)
Result Codes
OK If connected in data modem mode.
NO CARRIER If not connected in data modem mode.
Note: When the modem receives a break from the remote modem, break is passed to the
DTE as follows: In non-error correction mode direct, the break length is passed; in non-
error correction mode normal and in error correction mode, a 300 ms break is passed.