Longshine LCS-8156C1 - Manual (Page 149)

AT Commands for CX930xx Modem Reference Manual
102752B Conexant 4-7
+FAE - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates
identically to the +FAA command.
Syntax
+FAE=
Defined Values
Decimal number corresponding to the selected option.
0 Disable data /fax auto answer mode. (Default.)
1 Enable data /fax auto answer mode. The modem
determines the calling type and issues DATA
result code (13) if the caller is a data modem or
issues FAX result code (15) if the caller is a fax
modem.
After a data (not fax) connection is achieved (indicated by the DATA result code), the
DTE must issue an ATO command to cause the modem to go on-line.
+FTS - Transmit Silence
This command causes the modem to terminate a transmission and wait for 10-ms
intervals before responding with the OK result code.
Syntax
+FTS=
Defined Values
Decimal number from 0 (default) to 255 which specifies the
length of time in 10-ms intervals to delay before responding
with the OK result code after terminating the session.
Result Codes
OK Reported when transmission has been terminated for the
specified amount of time.
ERROR is invalid or this command is issued while the modem
is on-hook.
Reporting Supported Range of Parameter Values
Command: +FTS=?
Response: +FTS: range
Example: +FTS: 0-255