Longshine LCS-8156C1 - Manual (Page 78)

AT Commands for CX930xx Modem Reference Manual
3-54 Conexant 102752B
Defined Values
A string which specifies the preferred modem carrier to use in
originating or answering a connection. values are
strings of up to eight characters, consisting only of numeric
digits and upper case letters. values for ITU standard
modulations take the form: <1-4 digits>as needed>. Defined values are listed in Table 3-3.
A numeric value which enables or disables automatic
modulation negotiation (e.g., ITU-T V.32bis Annex A or V.8).
0 = Automode disabled.
1 = Automode enabled. (Default.)
and
Numeric values which specify the lowest () and
highest () rate at which the modem may
establish a receive connection. May be used to condition
distinct limits for the receive direction as distinct from the
transmit direction. Values for this subparameter are decimal
encoded, in units of bit/s. The possible values for each
modulation are listed in Table 3-3. Actual values will be
limited to possible values corresponding to the entered
and fall-back as determined during
operation. (Default = lowest () and highest
() rate supported by the selected carrier.)
and
Numeric values which specify the lowest () and
highest () rate at which the modem may
establish a transmit connection. Non-zero values for this
subparameter are decimal encoded, in units of bit/s. The
possible values for each modulation are listed in Table 3-3.
Actual values will be limited to possible values corresponding
to the entered and fall-back as determined
during operation. (Default = lowest () and
highest () rate supported by the selected
carrier.)