Longshine LCS-8156C1 - Manual (Page 123)

AT Commands for CX930xx Modem Reference Manual
102752B Conexant 3-99
S12 - Escape Prompt Delay (EPD)
S12 defines the maximum period, in fiftieths of a second, allowed between receipt of the
last character of the three escape character sequence from the DTE and sending of the
OK result code to the DTE. If any characters are detected during this time, the OK will
not be sent. Sending of the OK result code does not affect entry into command mode.
(See 3.1.3.)
Range: 0-255 1/50 of a second
Default: 50 (1 second)
S14 - General Bit Mapped Options Status
S14 indicates the status of command options.
Default: 146 (92h) (10010010b)
Bit 0 This bit is ignored.
Bit 1 Command echo (En)
0 = Disabled (E0)
1 = Enabled (E1) (Default.)
Bit 2 Quiet mode (Qn)
0 = Send result codes (Q0) (Default.)
1 = Do not send result codes (Q1)
Bit 3 Reserved
Bit 4 Result codes (Vn)
0 = Numeric (V0)
1 = Verbose (V1) (Default.)
Bit 5 Tone (T)/Pulse (P)
0 = Tone (T) (Default.)
1 = Pulse (P)
Bit 6 Reserved
Bit 7 Originate/Answer
0 = Answer
1 = Originate (Default.)
S16 - Test Mode Bit Mapped Options Status
S16 indicates the test in progress status.
Default: 0
Bit 0 Local analog loopback
0 = Disabled (Default.)
1 = Enabled (&T1)
Bits 1-7 Not used