Lippert Components LCI Motorized Leveling (2009 - Present) - Manual (Page 13)

Rev: 03.17.2014 LCI Motorized Leveling (2009 - Present) Owner's Manual
Page 13
Fig. 7A Fig. 7B
Clockwise for manual override Counter-clockwise for normal operation
Fig. 8 Fig. 9
Plastic Cap
Manual Override - Jacks
In the event that the jacks will not extend or retract, the valves can be manually overridden by using a 5/32”
Allen wrench (Pre-2006 model year, see update below) to turn the manual override clockwise on the valve.
(See Fig. 7A.) The leveling jacks can then be extended or retracted. Remember to turn the manual override
completely counterclockwise (See Fig. 7B) until it will no longer turn, to close the valve after the jacks have
been completely extended or retracted.
Manual Override - Power System
The Lippert Electronic Leveling System can be run with auxiliary power devices like electric drills, ratchet
wrenches or cordless screwdrivers. In the event of electrical or system failure, this manual method of
extending and retracting the jacks can be used. A standard handheld drill is all that is required. See the
instructions below.
1. Remove plastic cap (Fig 8).
2. Disconnect power cables on the motor.
3. Using a 1/2” socket, insert into auxiliary drive device, i.e. cordless or power drill. Insert socket onto
coupler found under plastic cap (Fig. 9).
4. Run drill in reverse or counterclockwise to retract jacks.