Lippert Components LCI Motorized Leveling (2009 - Present) - Manual (Page 12)

Rev: 03.17.2014 LCI Motorized Leveling (2009 - Present) Owner's Manual
Page 12
Jack Retract Procedures
1. Energize the system by pushing ON/OFF button on control panel. The ON/OFF light will be lit.
2. Push the RETRACT ALL JACKS button. All the jacks will start to retract and return to the full retract
position. When all jacks return to full retract position the JACKS DOWN light will go out.
NOTE: If you wish to stop the jacks from retracting, turn the system off and back on again by pushing the
ON/OFF button twice. You can then re-level the coach by following steps 1-5 again.
3. When the JACKS DOWN light goes out, push the ON/OFF button on the Control Panel to de-energize
the system. After a brief visual inspection around the coach to verify the jacks are fully retracted, you
may proceed to travel.
NOTE: When in the MANUAL mode, if the RETRACT button is pushed the jacks will only retract as long as the
RETRACT button is depressed. In AUTOMATIC mode, the RETRACT button need only be pressed
once and released for the jacks to fully retract.
Troubleshooting
Automatic Safety Shutoff
If the control panel is left on and inactive for four minutes it will shut off automatically. To reset the system
the coach ignition must be turned off, then back on and the ON/OFF button must again be pushed.
Drive Away Protection System
If the ignition is in the “RUN” position, jacks are down, and the operator releases the parking brake, all
indicator lights will flash and the alarm beeper will activate. The system will then automatically retract the
jacks until the jacks are fully retracted or the operator resets the parking brake.
The power unit will also operate to keep the jacks retracted in the event the leveling system loses pressure
as the coach is being driven.
Error Mode
If any problem is detected with the jacks, the system will enter Error Mode. Error mode may be recognized
by the blinking of Left, Center LCI and Right LEDs.
The following errors are detected by this system:
• Jack over current/short circuit.
• Jack under current/ open circuit.
• Jack extending too long (ground not detected after 2 min.).
• Jack retracting too long (fully retracted not detected after 2 min.).
• Out of stroke detection during auto cycle (if enabled).
The user must respond by pressing On/Off switch, which resets operation.
All normal features are disabled in Error Mode.
If panel loses communication with the controller for more than 5 seconds, the panel will blink the Jacks
Down, Park Brake and ON/OFF (if included) LEDs.