Lippert Components Ford Bumper Brace - Manual

HAPPIJAC
CO MPANY FORD BUMPER BRACE
505 N. Kays Drive, Kaysville, Utah 84037
INSTALLATION INSTRUCTIO NS
For all steps below, refer to photos on reverse
side of this page.
1. Locate the fender brace which runs from the
bottom of the bed to the bottom of the fender,
and remove the bolt at the bed end.
2. Place the bumper brace and bed brace, back
over this hole and restart the bolt.
(Do not tighten.)
3. Align the other end of the bumper brace over the
existing hole in the bottom of the bumper and
secure it with the hardware provided. (It may be
necessary to "tweek" the bumper back slightly to
make this alignment.)
4. Re-tighten the bolt under the bed holding the
fender brace and bumper brace.
5. Repeat steps 1 - 4 for opposite side.
insfmbb9110403