LABEC M-MIA-CC - Manual (Page 56)

Ultrasonic milk analyser
Operation manual 23.08.10 54/98
Make the printer power on. Press the LF Key and the SEL Key at the same
time, and then the printer print out the self-check scrip.
8.2.2. Consequence of actions when printing
The embedded printer is automatically switched on with switching on the
device. After finishing the measuring procedure the results are automatically
printed out. If there is a need of repeated printing of the same results the
operator has to press the button 1 on the embedded keyboard (each pressing
the button 1 on the keyboard the results will be printed out). If the operator
does not need to print out the results after the measurement is completed the
following has to be made:
1. Start Setup of the device (see p.7.1 Starting the device in service
Test/Setup mode).
2. Using the buttons up and down select menu Settings, page 2 results.
The display shows the following:
Settings Page2
Final clean cnt
Auto Print res
Exit
Choose Auto Print res. The display shows the following:
Auto Print res
No OK Yes
Now the operator may choose or cancel the automatic printing the results.
Additional printing out of the results by pressing the button 1 on the keyboard
is active even if the automatic printing is switched off i.e. pressing the button
1 will print out the results from the last measurement as many times as you
press the button 1.