KERN & SOHN VFB 2T-3 - Manual (Page 23)

23 VFB-BA-e-1310
8 Functions of display unit
8.1 Prior to weighing
8.1.1 Zero-point check
Prior to each weighing process ensure that the system is unloaded and clear of
obstructions. The display d
evice must show „0“, should this not be the case, press
the button.
8.1.2 Net weighing: Taring by button
The display unit offers an option that allows tare weights to be reset to zero by
pressing a button. In this way net weight changes can be traced. After taring, the
display unit will once again start at the smallest display step.
 Lifting a load, e.g. a pallet. The weight value of the pallet is displayed.
 Press button The weight value is stored as tare value.
The display unit goes to zero.
The lit up disp
lay “NET“, indicates that a tare weight is active.
 Place the sample, only the weight of the sample is displayed.
 Withdraw sample for other weighing and proceed with the new samples as
described before.
 Press to switch over between gross and net weight
When the pallet is removed, the display shows the weight of the pallet as a negative
value.
 Press the button anew, the system changes to the zero display.