Keri Systems SB-293 Quick Start - Manual (Page 5)

SB-293 Satellite Board
1530 Old Oakland Road, Suite 100 01837-003 Rev. 2.3
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 5 of 16
SB-293
Quick Start Guide
7.1 Two Door Configuration Connections
This configuration assumes JP12 is OFF, configuring the Satellite board for Two-Door control.
7.1.1 Output Relays
Please refer to Figure 4 on page 4 for output relay wiring locations.
See page 6 for a sample Fail-Safe Door Lock Output Relay drawing.
See page 6 for a sample Fail-Secure Door Lock Output Relay drawing.
See page 6 for a sample Alarm Output Relay drawing.
See page 7 for a sample Door Held Open – A-Door Relay drawing.
See page 7 for a sample Door Held Open – B-Door Relay drawing.
See page 8 for a sample General Purpose Normally-Open Output Relay drawing.
See page 8 for a sample General Purpose Normally-Closed Output Relay drawing.
Table 2: Output Relays
TB-7/TB-10 Relay Outputs Description
TB-7 – Pin 1 lock output – normally open line
TB-7 – Pin 2 common/ground
TB-7 – Pin 3 lock output – normally closed line
TB-7 – Pin 4 alarm output – normally open line
TB-7 – Pin 5 common/ground
TB-7 – Pin 6 alarm output – normally closed line
TB-10 – Pin 1 GPO 3/DHO-B a – normally open line
a. The Door Held Open (DHO) alarm feature is not available in
16-bit Doors software applications.
TB-10 – Pin 2 common/ground
TB-10 – Pin 3 GPO 3/DHO-B a – normally closed line
TB-10 – Pin 4 GPO 4/DHO-A a – normally open line
TB-10 – Pin 5 common/ground
TB-10 – Pin 6 GPO 4/DHO-A a – normally closed line