Kenton Pro-SOLO MkII - Manual (Page 4)

4
Below is a list of parameters available to edit. The letters in square brackets show [where
applicable] what will be shown in thevalue display.
Menu
number Parameter
(default)
01
MIDI receive channel (default :1)
Range 1 to 16
- Sets the MIDI receive channel.
02 Multiple trigger (default: on)
Range
on [on] / off [of]
- If set to on (multiple trigger mode), a new valid note will briefly turn off the gate to retrigger
the envelope generators of the mono-synth. If turned off (normal trigger mode), the gate
stays on when a new note is played.
03
Note priority (default: new)
The following can be selected;
Low note priority
[lo]
High note priority [hi]
New note priority [nn]
- Sets the note priority for the converter.
If set to "lo" then the lowest valid note played takes precedence.
If set to "hi" then the highest valid note played takes precedence.
If set to "nn" then the newest valid note played takes precedence.
The PRO-SOLO has a note buffer memory so that trill effects can be achieved.
04 Pitchbend range (default: 2)
Range 0 to 12 semitones.
- The pitch bend range can be changed in semitone steps.
05 Portamento controller number (default: 65)
- Sets which MIDI controller will turn on/off the portamento function.
The following can be selected;
Auto portamento
[AU] normally off but legato playing turns portamento on
On [on] always on
Off [of] always off
Program change [PC] program 1=on program 2=off
MIDI controllers #0 to 120 values above midway=on, below midway=off
The standard MIDI controller for portamento on/off is #65 which is the default, but with this
command , the PRO-SOLO allows you to use another controller, a program change, direct
control or Auto Portamento if you wish.
PARAMETERS