Kenton Pro-SOLO MkII - Manual (Page 3)

3
Switching On
When the PRO-SOLO is switched on, the words KENTON PRO-SOLO scroll across the display.
The Display
The display has 3 digits each with a dot above. The 1st dot when lit indicates that PARAMETER
mode is currently selected. The middle dot when lit indicates that VALUE mode is currently
selected. The 3rd dot will light whenever the PRO-SOLO`s GATE is on (key pressed down).
Stepping Through Parameters
Ensure that the PARAMETER dot is lit. If you need to, you can change between PARAMETER
and VALUE modes by briefly pressing the SELECT button, you can then use the INC and DEC
buttons to scroll through the available parameters. The available parameters are printed on
the case of the Pro-SOLO for convenience. For additional confirmation, a “P” will appear in
the left digit when parameter mode is selected.
Changing Values
Ensure that the VALUE dot is lit. You can change between PARAMETER and VALUE modes by
briefly pressing the SELECT button. You can then use the INC and DEC buttons to scroll through
the available values. The left digit is used for displaying the hundreds portion of the value if
applicable. It will also have a horizontal dash if a minus value is to be displayed. Minus values
up to –127, or positive values up to 255 are used.
Speeding up editing
If you press and hold the INC key, then also hold the DEC key, the value will increase faster. If
you press and hold the DEC key then also hold the INC key, the value will decrease faster.
Storing Set-ups
The set-ups can be stored in non-volatile memory. To do this, press & hold the SELECT button
(for approx. 6 seconds) till the display reads `st` (store).
EDITING THE PRO-SOLO mkII
Gate On
Parameter mode
Value
mode
Minus