Ap10 serial commands, Dial, Appendices ~ appendix c: serial commands – ClearOne AP10 User Manual

Page 27

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

AP10 Serial Commands

Command

Function

Sets auto-answer for a telco channel

DIAL

Dials a DTMF sequence or reports last sequence dialed

HOOK

Sends a hook flash to the telephone line

LVL

Reports the level of the transmit or receive channel (read only)

MUTE

Sets the mute for the transmit or receive channel

NULL

Re-nulls the AP10 to the telephone line

RING

Ring acknowledgement

Selects/reports the connect state of the unit

TERL

Reports the telco echo return loss (read only)

TERLE

Reports the telco echo return loss enhancement (read only)

UID

Reports the unit identification number

VER

Reports the current firmware version

This command activates and deactivates the auto-answer feature.

Command form: DEVICE AA

Explanation: is the action (i.e. auto-answer enable, auto-answer disable,

current state)

X=0

Parameter disables auto-answer

X=1

Parameter enables auto-answer

X=2

Parameter to toggle the state from one state to the other

(regardless of current state)

X= Null

Parameter to report back the current state.

DIAL

DTMF tones can be generated through the AP10. This capability remains active after

a call is placed, so tones can be issued for use with voice mail and pagers. If the

AP10 is not connected when this command is issued, the unit will connect to the

line first, then dial the tone(s).

Command form: DEVICE DIAL

Explanation

is any valid combination of touch tone characters. A

comma indicates a two-second pause. STRING has a maximum length of 40

characters. Valid characters are: 0 through 9, #, * and ,

Appendices

~ Appendix C: Serial Commands