ClearOne AP10 - Manual (Page 20)

Operation ~ Using the Telco Interface 16
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
3. When the conversation is complete, press the Off button [E] to disconnect
the call. You can also disconnect using an external controller. If the handset
is off hook, audio will be routed to the telephone.
If your call is through the handset only (the red Off LED will be lit), hang up
when the conversation is complete.
To make and disconnect a call
1. Open AP-Ware and select the AP10 unit.
2. Click the AP10 Telco button on the Flow Screen to open the Telco interface.
3. Activate the telephone interface by clicking On or by beginning to dial.
4. When the green light below the On button illuminates, enter the number to
be dialed, including any dial-out prefixes.
5. Click Send. If you clicked directly on the number buttons, the call will be
completed as you finish dialing—just like using a standard telephone.
6. When you are finished with the call, click Disconnect to end the call.
Using the Telco Interface
Figure 4.2. Telco dialing interface
Detailed instructions on
creating site files and
using AP-Ware can be
found in the AP-Ware help file.
✍