Pin definitions – Cypress CY7C1166V18 User Manual
Page 7
CY7C1166V18, CY7C1177V18
CY7C1168V18, CY7C1170V18
Document Number: 001-06620 Rev. *D
Page 7 of 27
ZQ
Input
Output Impedance Matching Input. This input is used to tune the device outputs to the system data
bus impedance. CQ, CQ, and Q
[x:0]
output impedance are set to 0.2 x RQ, where RQ is a resistor
connected between ZQ and ground. Alternatively, this pin can be connected directly to V
DDQ
, which
enables the minimum impedance mode. This pin cannot be connected directly to GND or left uncon-
nected.
DOFF
Input
DLL Turn Off
− Active LOW. Connecting this pin to ground turns off the DLL inside the device. The
timings in the DLL turned off operation is different from those listed in this data sheet. For normal
operation, this pin can be connected to a pull up through a 10K
Ω or less pull up resistor. The device
behaves in DDR-I mode when the DLL is turned off. In this mode, the device can be operated at a
frequency of up to 167 MHz with DDR-I timing.
TDO
Output
TDO for JTAG.
TCK
Input
TCK Pin for JTAG.
TDI
Input
TDI Pin for JTAG.
TMS
Input
TMS Pin for JTAG.
NC
N/A
Not Connected to the Die. Tie to any voltage level.
NC/36M
N/A
Not Connected to the Die. Tie to any voltage level.
NC/72M
N/A
Not Connected to the Die. Tie to any voltage level.
NC/144M
N/A
Not Connected to the Die. Tie to any voltage level.
NC/288M
N/A
Not Connected to the Die. Tie to any voltage level.
V
REF
Input-
Reference
Reference Voltage Input. Static input used to set the reference level for HSTL inputs, outputs, and
AC measurement points.
V
DD
Power Supply Power Supply Inputs to the Core of the Device.
V
SS
Ground
Ground for the Device.
V
DDQ
Power Supply Power Supply Inputs for the Outputs of the Device.
Pin Definitions
(continued)
Pin Name
IO
Pin Description