Canon AXIS 1610 - Manual (Page 21)

AXIS 1610 User’s Manual Section 3: Installation 21
2. Update, if necessary, your host table and alias name databases,
as required by your system.
3. If it is not already running, start the RARP daemon. This is
typically performed using the
rarpd -a
command.
4. Restart the AXIS 1610 to download the IP address.
Note: ❏ If you are using IBM AIX, you will probably not have access to a
RARP daemon. If this is the case, you can use either the ARP or
BOOTP methods instead.
Using BOOTP
in UNIX
Follow the instructions below to set the IP address using BOOTP
1. Append the following entry to your boot table. This is typically
performed by editing the file:
/etc/bootptab
Example :
Notes: ❏ Enter the
ht
and
vm
fields exactly as shown in the example.
❏ The
ha
field is the Ethernet address/node address and the
ip
field
is the IP address of your AXIS 1610.
❏ The
gw
and
sm
fields correspond to the default router address and
subnet mask.
2. If necessary, update your host table and alias name databases, as
required by your system.
:ht=:vm=:\
:ha=:ip=:\
:sm=:gw=
npsname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=192.168.3.191:\
:sm=255.255.255.0:gw=192.168.1.1