Conair WSB - Manual (Page 27)

Press RCP to look at another recipe. Display = (GET __).
Enter 2 digits to retrieve one of 99 recipes.
Display will flash through the current stored data:
(RCP __), (R = xx ), (C = xx.x), (A = xx.x), (*TO LOAD)
Press * to LOAD this recipe into memory.
Routine will exit automatically.
Press RCP or EXIT to return to the display (GET __).
Press RCP or EXIT again to exit.
To SAVE a RECIPE you must be in the PROGRAM mode.
If you press RCP key again after display of (GET __),
display says (SAVE __). Enter 2 digits, display will say
(SAVING ). The current settings are saved into memory
under the recipe number you have entered. These are
normally the THUMBWHEEL switch settings.
CAUTION: If settings have been entered by KEYPAD or RECIPE,
then these are the ones that will be saved. Therefore, when
saving a recipe, be certain that no other recipe is
currently loaded, and that no keypad-entered settings are
currently loaded. The lower right corner of 3 LEDs should
be off indicating thumbwheels are being read.
To clear a stored recipe, set all thumbwheel switches to
zero and enter these zero settings into the recipe location.
Routine will EXIT automatically.
EXIT will exit at any time.
When a RECIPE is loaded, three LEDs, (R, C, A, Locked
out) light indicating that the thumbwheel settings do not
represent the settings that are being run by the controller.
Whenever internally stored settings are not the same as the
thumbwheel settings, these three LEDs light to indicate this
condition. These LEDs correspond to REGRIND, COLOR, and
ADDITIVE settings respectively.
NOTE: To allow the operator the ability to stop running any
single component, a thumbwheel setting of all ZEROS (00.0)
can be accepted as valid to override any setting entered by
a Recipe. If you want this override option, enter a 0
(_SE 0xxxx) as the first digit in the SE parameter. The
default entry of 1 (_SE 1xxxx) indicates the override option
is turned off. See PARAMETERS; SE.
BATCH: This key allows you to blend a PRE-SELECTED WEIGHT of
(BTCH) material, and then STOP running and sound the ALARM. The
process may also be programmed to sound the alarm but
continue running. Since each cycle will always blend a full
weigh bin amount, the total amount blended may exceed the
target batch weight by up to one cycle's blend weight.
This key is NOT FUNCTIONAL unless the last digit of the
"FLG" parameter is set to 1 or 2 (xxxx1). To do this, see
the SOFTWARE MAINTENANCE section, PARAMETER TABLE, "FLG".
The ALARM SILENCE button on the side of the controller, is
Page 28