Citation Stereo Receiver - Manual (Page 58)

• Stereo reproduces the front left and right channels through those speakers only.
• Mono invokes enhancement circuitry which create an enveloping soundfield from a monophonic
input signal; it can be a significant improvement when watching movies with mono sound.
Once you have selected a mode to customize, you will find many of the same attributes listed which
may be modified to your preference as were associated with analog modes.
Two different attributes which may be modified are the last two on the menu (Figure OSD-30).
They are
Subs Level and Auto Mode Sel .
• Subs Level gives the user the ability to raise or lower the sound level coming from the sub-
woofer(s) when a particular mode is chosen. Use the › or ‹ Menu Control buttons to raise or
lower the subwoofer level as desired.
• Auto Mode Sel (ect), when turned off, will mute the 5.0 if the signal is of a type other than
selected on the MODE line above. For example, if, on the MODE line, DTS has been selected and a
Dolby Digital source is fed to the 5.0, it will mute until either a DTS signal is supplied or another
mode is selected.
Remote Zone
If you have connected an amplifier, remote infrared sensor and video monitor to the appropriate rear
panel connections of the 5.0, people in a secondary location in your home will be able to select signal
sources and volume levels independent of what is selected in the primary zone. It is not necessary for
the 5.0 to be turned on; power (for the 5.0) can also be controlled from the second zone.
It will be necessary to equip the remote zone with its own remote control, as all selections are made via the
controls under the
Secondary Control Cover on the remote.
Setting Up the Remote Zone
The various options available to configure the remote zone are accessed through the Remote Zone
menu. Press the Menu button ˙ on the remote control, and then press the ¤ Menu Control button
once to highlight Remote Zone . Press the › Menu Control button to display this menu
(Figure OSD-31).
Figure OSD-31
Lines 1 through 6 of this menu allows the selection of which video source will be associated with the
analog (only) audio source in the remote zone. Press the
¤ Menu Control button to highlight
Input-1 . Then press the › Menu Control button to select which video source (composite video
sources 1 through 6, and/or S-video sources 1 and 2) will be associated with this analog input in the
remote zone only; it may be associated with another video source in the main zone. Select a video
source for each analog audio source to be accessed in the remote zone; for music-only sources, select
a video input which is not connected to a video source.
R e m o t e Z o n e
<
M a i n M e n u <
1 : I n p u t 1 C O M P 1
2 : I n p u t 2 C O M P 2
3 : I n p u t 3 C O M P 3
4 : I n p u t 4 C O M P 4
5 : I n p u t 5 C O M P 5
6 : I n p u t 6 C O M P 6
R e m Z o n e M s g s O N
O u t p u t M o d e V a r i a b l e
58
Advanced Featur
es