Cradlepoint MBR95 User Manual
Page 19
CRADLEPOINT MBR1400 | USER MANUAL Firmware ver. 3.2.2
© 2011
CRADLEPOINT, INC. PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 17
3.3.3
Your MBR95 router gets an IP conflict when you plug it into your Cable or DSL modem.
If your Cable or DSL modem is not working with the router, check that there is not an IP conflict. Go to
Internet →
Connection Manager and find the Ethernet connection under WAN Interfaces. If it says ―IP conflict‖ you will need
to change the IP address of the MBR95 router from
―192.168.0.1‖. A suggested IP address is ―192.168.10.1‖.
Change the IP address by going to
Network Settings→ WiFi / Local Network. Find the IP address under ―LAN
Settings‖ and type the alternate IP address. Click
Apply to save the settings.
NOTE: To access the router administration pages after changing the IP address you will need to go to the new IP address in your internet browser
instead of ―http://192.168.0.1‖. You may continue to use ―cp/‖ to access the router administration pages after this change.
If you are still unable to access the internet after following the above directions, contact CradlePoint Technical Support for
further assistance.