Philips FW391C - Manual (Page 17)

Compact Disc
Programming Tracks
Programming tracks of a loaded CD is possible in the stop mode
of the CD. The display will indicate the total tracks stored in the
program. Up to 40 tracks can be stored in-the memory in any
order. When 40 tracks are stored and you attempt to store
another track, the display will show "PRUBRRt'l FULL“.
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
— The PROGRAM flag flashes on the display.
3 Press the desired disc button to select the disc.
4 Press PREV or NEXT ►W to select the desired track.
5 Press PROGRAM to store the track.
• Repeat steps 3 to 5 to store other discs and tracks.
6 Press STOP»CLEAR once to end programming.
The total number of tracks programmed and total playing
time will appear on the display.
Playing the program
1 Press PLAY»PAUSE to start program playback.
-*■ The track number and elapsed playing time of the
current track will appear on the display.
2 Press STOP»CLEAR to stop program playback.
Note:
If you press any of the 3 CD DIRECT PLAY buttons, the set will
play the selected disc, and the program will be ignored
temporarily. The program flag will also temporarily disappear from
the display, then reappear when the playback for the selected
disc ends.
Reviewing the program
Reviewing of a program is only possible in the stop mode.
• Press PREV or NEXT repeatedly to review the
programmed tracks.
Erasing the program (in the stop position)
• Press STOP«CLEAR.
-* “PROGPR m CLEHPCi''appears on the display.
Note:
The program is also erased when the set is switched off. If the
CD carousel is opened, the tracks belonging to the outer two
trays will be erased and TLFRRE]]" will flash on the display
once.
CD Recording
During CD recording,
• it is not advisable to fast forward/rewind your cassette in
TAPE DECK 2.
• it is not possible to listen to another sound source.
CD Recording
1 Load a blank cassette (full spool to the left) into TAPE
DECK1.
2 Press SOURCE to select CD.
3 Load a disc into the disc tray.
4 Press PREV or NEXT to select the desired track.
If desired, you can program the tracks in the order you want
them to be recorded (see Programming Tracks).
5 Press RECORD on cassette TAPE DECK 1 to start
recording.
The RECORD flag flashes on the display.
— The CD starts playing.
6 Press STOP'CLEAR on the CD player and STOP»OPEN on
cassette TAPE DECK 1 to stop recording.
"o)
15