Philips FW391C - Manual (Page 13)

Tuner
Vi
“oi
c
UJ
Tuning to radio stations
1 Press SOURCE to select TUNER.
2 Press BAND to select the desired waveband: FM or AM.
3 Press TUNING I<^or^>-l for more than one second.
The display will show 'SCRPCJ-I' until a station with
sufficient signal strength is found.
• Repeat this procedure until the desired station is reached.
• To tune to a weak station, briefly press TUNING K^or
►►I until the display shows the right frequency and/or
when the best reception has been obtained.
Storing Preset Stations
You can store up to 20 stations in the memory. When a preset
station is selected, the preset number appears next to the
frequency on the display.
Automatic programming
1 Press BAND to select the desired waveband: FM or AM.
2 Press AUTO PROGRAM for more than 1 second to start the
automatic programming.
PROGRAM flashes and 'RLITD' is displayed.
Every available station will be stored automatically. The
frequency and preset number will be displayed briefly.
-*■ It will stop searching when all the available stations are
stored or when 20 preset stations are stored.
• You can cancel the automatic programming by pressing
AUTO PROGRAM; TUNING l^^or>>l ; PRESET Tor
A; or BAND.
Manual programming
1 Press AUTO PROGRAM for less than 1 second.
— PROGRAM flashes on the display.
2 Press BAND to select the desired waveband.
3 Press TUNING [◄◄orM-I to tune to the desired
frequency.
4 Press PRESET T or A to select a preset number.
5 Press AUTO PROGRAM again.
-* PROGRAM disappears, and the station is stored.
• Repeat the above procedure to store other preset stations.
Tuning to Preset Stations
• Press PRESET T or A (or PREV or NEXT on the remote
control) to select the desired preset number.
The preset number, frequency and waveband appear on
the display.
Note:
If you wish to maintain some previous set program stations,
select the preset number after the last set station, then start the
automatic programming.
11