Philips Matchline 55PP9753 - Manual (Page 9)

Connecting aVCR
1
2
3
4
5
6
Connect the incoming antenna or cable
TV signal to the ANT IN jack on the
back of the VCR.
Back ofTV
Using a coaxial cable, connect the
ANT OUT j ack on the back of the
VCR to the ANTENNA IN 75Q jack
on the back of the TV.
Using AN cables, connect the AUDIO
and VIDEO OUT jacks on the back of
the VCR to the corresponding INPUT-
AV 2 audio (L and R) and video (V)
jacks on the back of the TV.
Press the Source button on the remote
control to access the Source list.
Press the Cursor Up or Down button to
select the AV2 input source.
Press the OK button to confirm your
choice. The set is now switched to the
AV2 input source for the viewing of pro­
grams from the VCR.
NOTE: Since you’ve connected the
cable TV signal directly to the TV’s
tuner (step 2 above), you can watch the
unscrambled programs by simply tun­
ing to the desired channel. To store
chaimels in the TV’s memory, you
must use Autoprogram, which you can
access through “Install” in the TV’s
on-screen menu. See the Autoprogram
section in the
QuicIc Use and Setup
Guide that came with the TV. If you
use Autoprogram, you can select chan­
nels by pressing the CH + or - buttons
on the TV remote control (in TV
mode). Otherwise, you must press the
digit (number) buttons to tune directly
to the channel you desire.
Color Coding Used on Jacks and Plugs to
simplify connections:
Yellow: VIDEO (Composite Video)
Red: Right AUDIO
White: Left AUDIO.
Incoming
Cable TV
or
Antenna
Signal
TY
AVI:None
CVI: Mone
1 Source AniNoiK 1
AV3:Kone---------- ^
AV4:Nene
SIDE:None
O © ©
© © ©
© © ©
© © ©
(a) (a)
/ II \
O 0 0 1
Z = l O I
i a = n l