Interlogix TruVision IP Open Standards Outdoor Cameras User Manual - Manual (Page 44)

4BChapter 5: Camera management
40 TruVision Outdoor IP Camera User Manual
To format the SDHC card:
1. Click the HDD Management folder to open its window.
2. Click Select All in the HDD Number column to select the SDHC card. Only
one HDD option is listed.
3. Click Format . A window appears showing the formatting status.
Restoring default settings
Use the Default menu to restore default settings to the camera. There are two
options available:
 Full mode: All parameters are restored to factory default settings.
 Basic mode: All parameters are restored to factory default settings except for
the network settings IP address, subnet mask gate and port.
You can also do a hard reset by pressing the INITIAL SET button on the base of
the camera (see Figure 3 on page 7).
To restore default settings:
1. Click the Default folder to open its window.
2. Click either Full mode or Basic mode . You will receive a prompt asking you
to reboot the camera.
Upgrading the firmware
The camera firmware is stored in the flash memory. Use the upgrade function to
write the firmware file (digicap.DAV) into the flash memory.
You need to upgrade firmware when it has become outdated. When you upgrade
the firmware, all existing settings are unchanged. Only the new features are
added with their default settings.