Vertical Communications TeleVantage 7.5 User Manual
Page 90
7-18
3.
Select the parameter
Derive Primary Clock From (User Defined)
and then select a
FrontEnd_x
value from the
Value
drop-down list that corresponds to the span that is
connected to the telephone company. For example, if the first span is the one that is
connected, select
FrontEnd_1
.
4.
Click
OK
.
Go to the next section.
Configuring boards for use outside of North America or Japan
If you are located in North America or Japan, go to “Board-specific configuration tasks” on
page 7-19.
If you are located outside North America and Japan, you must configure all your Intel Dialogic
boards to use the a-law audio format.
Important:
You use DCM to specify the a-law format for all boards except for DSIx boards. You
use the Intel MEA Configuration program to specify the a-law format for DSIx boards.
To specify a-law format for all boards except DSIx boards
1.
In the DCM main dialog box, under
TDM Bus,
double click
Bus-0
.
2.
Select
Media Type (User Defined)
from the list.
3.
Select
ALaw
from the
Value
drop-down list.
4.
Click
OK
.
Note:
During the TeleVantage Server installation, which is described in Chapter 9 in
Installing TeleVantage, you will choose your voice files format and your country.