IC Realtime Specialty: 4-CH Mobile DVR - Manual (Page 121)

121
7.3.7 Mobile Configuration
Mobile configuration interface is shown as in Figure 7-56.
Figure 7-56 Mobile Configuration
Please refer to the following sheet for detail information.
Parameter Function
Send event
message Device can send the event message (alarm information, motion detection
and etc) to the mobile user. You can check the box to enable the function.
Receiver You can input one or more mobile number(s) here to receive the
message.
SMS activate The mobile user can send out message to activate the device to connect
to the 3G network.
You need to check the box to enable current function.
Sender You can input several senders’ mobile number here.
Dial activate The mobile user can give a call to activate the device to connect to the 3G
network.
You need to check the box to enable current function.
Caller You can input several senders’ mobile number here.
Add Click it to add the corresponding mobile phone user.
Delete Click it to remove the corresponding mobile phone user.
Message type
There are two types: SMS and MMS.
Right now system supports SMS only.
Title You can input message subject here.
Event message
save System can save the message receiver number so that device can send
out alarm (motion detect) message to the specified mobile phone(s).